Frontpage Products Self-levelling compound "Mix" TopCoat Design

TopCoat Design

Ultra matt topcoat for levelled industrial looking floors

Final treatment of cement-based levelled floors
Interior application in dry rooms
Ultra matt transparent look
Enhances surface strength
Ready for use and easy to apply
High wear and water resistance
Re-applicable in areas subjected to mechanical stress
High waterproofing

Retailers

Product information

Application

Surface preparation

The surface should be dimensionally stable, dry, fully cured and dust-free
Any laitance left on the surface should be removed by grinding before surface treatment with Alfix Top-
Coat Design is applied.
For further information, please consult our Technical Services Dept.

How to use

Always shake container well before use to dissolve any precipitate

For highly absorbent surfaces, apply first coat of Alfix TopCoat diluted with up to 10% clean water. Apply
by short-haired paint roller for even and full coverage leaving no visible puddles.
Leave to dry for at least 3 hours before applying second coat Alfix TopCoat Design by short-haired paint
roller.

Leave to dry for another 3 hours to dry or await the following day until applying the third and final coat of
Alfix TopCoat Design.

Observe that temperature at ceiling, floor and product should range from +15°C to +25°C.
Min. drying time at +20°C: 3 hours between each application.
Allow floor to dry for at least 24 hours at +20°C before taking into use.

Cleaning

Clean residues from tools with water before the dispersion sets. Once dried, Alfix TopCoat Design can be
removed mechanically.

Daily maintenance
The floor surface should be maintained as a lacquered or oil-treated floor.
For washing, Alfix Gulvpleje or a similar detergent with the same specifications is recommended.

NB!
Alfix TopCoat Design is recommended for floors in living spaces or other floor areas where the load on the
floor is comparable with the load in living spaces.
For floor areas with a greater load than in living spaces, more frequent maintenance should be expected.
Use of an underlay below office chairs with castors is recommended.
For chairs and other objects that are often pulled across the floor, we recommend fitting felt pads or similar
below the chair legs etc.
We recommend placing mats on the floor surface by entrances.
Spillages on the floor should be wiped up before drying.
For further information, please contact our Technical-Service department.

Downloads

TopCoat Design

Product

Coverage

Packaging

Tests

Technical data

Surface preparation

How to use

Cleaning

Guidance

Downloads