Acid-resistant bonding agent
To be used as primer and moisture barrier prior to application of Alfix Epoxy membrane.
- For interior and exterior use
- High bonding efficiency
- High chemical resistance
Products
Acid-resistant bonding agent
To be used as primer and moisture barrier prior to application of Alfix Epoxy membrane.
Product information
2-part epoxy resin system scattered with dry quartz sand, grain size 0.32 – 0.71 mm (type 1)
200 – 300 g/m² + approx. 2.5 kg sand.
5 kg units containing matching volumes of each component, A and B.
Sand is available in 25 kg bags.
Produktinfo for:
• Alfix Epoxy Membran
Brochuren: Bassin - Flisebeklædning i svømmebadsanlæg
Sikkerhedsdatablad
Arbejdstilsynets bekendtgørelse nr. 1793 af 18.12.2015.
Arbejdstilsynets vejledning 9.3.3 af 28.11.2019
I tvivlstilfælde, kontakt vores Service-tekniske afdeling.
For seneste ajourførte udgave af dette datablad, besøg alfix.com
For regular cleaning and maintenance of e.g. terracotta, unglazed ceramic tiles, marble, and natural stone.
Further for pore filling of absorbent surfaces.
Application
Concrete in situ and concrete slabs, older than 3 months.
Cohesive strength should be min. 1.5 N/mm²
The surface should be dry, dimensionally stable, sound, clean and free from dust and laitance. There
should be no blooms or crack formations. Surface evenness of +/- 2 mm when using smoothing board,
Residues from grease or soap can be removed with Alfix Deep Cleaner.
Add full content of component B into component A and mix the two components using slowly rotating
paddle attached to electric drill. Mix thoroughly for approx. 3 minutes.
Working time is approx. 30 minutes at +20°C
Apply by short pile paint roller to an evenly penetrating coat with coverage of 200 – 300 g/m².
Scatter with dry quartz sand, type 1, over the still wet coating of Alfix Epoxy primer until the surface is
completely saturated and will provide a sandpaper-like finish.
NB!
Both substrate and working temperature should be ranging between +10°C - +30°C.
Avoid working in direct sunlight.
According to Danish legislation, working with epoxide products requires special training.
Finishing
Remove any excess and loose sand by sweeping or vacuuming the surface. Any further treatment with
Alfix Epoxy Membrane cannot be made until the primer is fully cured, allow min. 16 hours.
Residues from Alfix Epoxy primer on tools should be removed immediately upon use with ethanol. Once
cured, primer can only be removed mechanically.
Downloads